手柄消毒保养流程（一）

一：清洗

不要浸泡手柄

用干净的软布蘸消毒剂擦拭手柄及手柄导线。

轻轻地用蘸水的软毛刷清洁手柄，确保所有的通道都清洁干净。用温和的清洁剂去除手柄中的杂物。

淋洗时，手柄前端向下放置。

用光滑的毛巾擦干手柄，确保导线一端电源接口的干燥

用少量的医用硅树脂喷手柄的外部和前端。

存放前，请拭干

手柄清洁后应立即消毒。

清洗注意点:

总是垂直握住手柄以防止任何液体进入电机(马达)

如果使用洗碗机，让手柄垂直放置（马达向上）让水控干

禁止使用润滑剂、浸液冲洗，禁止将手柄放置于清洁剂或任何液体中

尽可能使手柄始终保持干燥，以防止湿气侵蚀，特别是在灭菌和存放中

作用：冲洗的作用是以防时间过长,血渍或组织物凝固堵塞手柄传动部位

1： Cleaning

Do not soak the handle

Wipe the handle and handle wire with a clean soft cloth dipped in disinfectant.

Gently clean the handle with a soft brush dipped in water to ensure that all channels are clean. Use mild detergent to remove sundries from the handle.

When rinsing, place the front end of the handle downward.

Dry the handle with a smooth towel to ensure that the power interface at one end of the wire is dry

Spray the outside and front end of the handle with a small amount of medical silicone.

Wipe dry before storage

Disinfect the handle immediately after cleaning.

Precautions for cleaning:

Always hold the handle vertically to prevent any liquid from entering the motor (motor)

If using a dishwasher, place the handle vertically (motor up) and let the water control dry

Do not use lubricant or immersion solution for flushing, and do not place the handle in detergent or any liquid

Keep the handle as dry as possible to prevent moisture erosion, especially during sterilization and storage

Function: the function of flushing is to prevent the transmission part of the handle from being blocked by blood stains or tissue coagulation for a long time